P/N: MIT65B40026
Plug – Oxygen System
To plug the oxygen outlet receptacles on the flight deck for pressure & leak test of the oxygen system. For push-to-lock type receptacles.
747
129 Trace
For more information contact: TFASI
February 2 2013
AD #3069
P/N: G21001-1
Manufacture: Spec Tool
Lock out test switch N2 engine speed discrete PCA
Used to hold the channel 1 or channel 2 switch on the N2 engine speed discrete PCA’s in the test position to simulate engines on condition during test of the equipment cooling system.
747-400 ONLY
(Ref 747-400 21 AMM)
129 Trace
For more information contact: TFASI
February 2 2013
AD #3068
P/N: MIT65B81226
Spanner sockets elevator control feel unit
Used to torque nuts (BACN10 grip) on camshaft assembly (65B81228) of feel unit assembly elevator control (65B81226). Two sockets are required, one for each of the camshaft assembly (65B81228).
747
For more information contact: TFASI
June 20 2011
AD #2881
P/N: ST2580-245
3 inch nominal across the flats
Used to tighten & torque the nut used to retain the body gear retract actuator rod end to the threaded boss on the gear.
747
129 Trace
For more information contact: TFASI
June 16 2011
AD #2877
P/N: 2TE65B50357
Manufacture: Industrial Automation
Gas Generator Simulator assembly test Jig. Use to simulate gas generator units during test of emergency escape system on the aircraft & to measure the ability of the actuation cable to operate the trigger mechanism.
747
For more information contact: TFASI
March 1 2011
AD #2842
P/N MIT65B04308-1
Cargo door mechanism torque adapter set. Used to torque the latch mechanism bearing retaining nuts of the forward & aft lower lobe main cargo doors and main deck side cargo door.
747
For more information contact: TFASI
March 1 2011
AD #2841
P/N MIT65B40110
Pacific Support Equipment, Ltd
747 (Applicable to QAN only)
Lamp removal tool, Lamp Indicator Module. Used to remove indicator lamp module assemblies from panels (Ref 747 chapter 33 AMM)
For more information contact: TFASI
July 20 2009
AD #2625
P/N 6ME65B02200-1
Manufacture: Pacific Support Equipment, LTD
Inboard Aileron Locks Left & Right
Used to lock either of the inboard ailerons in any of three positions for maintenance. 20 degrees up, 20 degrees down or faired.
747 ALL (except -800)
For more information contact: TFASI
2009-26-01
AD #2480
P/N 2MIT65B51544
main door latch gage set
Used to check the over center position of center bell cranks of the upper & lower door gates. (Ref 747 Chapter 52 AMM & CMM)
747
For more information contact: TFASI
Oct 26 2008
AD #2402
P/N TE65B83189
747 Rudder ratio control system test unit
Applicable to 747-100/-200/-300 only.
Used to detect defects in the tested rudder ratio comparator, actuator or controller. The tester allows for voltage readings to be taken with a voltmeter to check for the correct parameters.
Two available
Both Certified
For more information contact: TFASI
Sept 25 2008
AD #2386