P/N: F70312-15
MLG Fwd trunion bearing retaining nut torque adapter
F70312-15 replaces F72905-1 & is applicable for airplane line no. 936 that have no incorporated SB 57-129.
727
For more information contact: TFASI
March 16 2011
AD #2855
Category Archives: Boeing
GAS GENERATOR SIMULATOR ASSEMBLY TEST JIG
P/N: 2TE65B50357
Manufacture: Industrial Automation
Gas Generator Simulator assembly test Jig. Use to simulate gas generator units during test of emergency escape system on the aircraft & to measure the ability of the actuation cable to operate the trigger mechanism.
747
For more information contact: TFASI
March 1 2011
AD #2842
TORQUE ADAPTER SET
P/N MIT65B04308-1
Cargo door mechanism torque adapter set. Used to torque the latch mechanism bearing retaining nuts of the forward & aft lower lobe main cargo doors and main deck side cargo door.
747
For more information contact: TFASI
March 1 2011
AD #2841
LINEAR SERVO ACTUATOR LINE TEST SET
PN: 5916816-501
Manufacture: AeroInfo
Used for checkout & adjustment of the Electrical & mechanical positioning of both Servo Actuators during Rigging of the MACH TRIM Compensator Actuator & yaw damper actuator.
MD80 series
Certified 2018
For more information contact: TFASI
February 11 2010
AD #2748
747 LAMP REMOVAL TOOL
P/N MIT65B40110
Pacific Support Equipment, Ltd
747 (Applicable to QAN only)
Lamp removal tool, Lamp Indicator Module. Used to remove indicator lamp module assemblies from panels (Ref 747 chapter 33 AMM)
For more information contact: TFASI
July 20 2009
AD #2625
FAULT ISOLATION SLAT DISAGREE TEST SET
P/N 2780-D80-1235
Manufacture: AeroInfo
MD80 / 90 series Fault Isolation Slat Disagree Test Set. Monitor eight slat position proximity sensors & three position flap handle switches in slat advisory system, has memory.
Certified 2018
For more information contact: TFASI For All Your Aircraft Needs!
July 3 2009
AD #2620
WRENCH
P/N F72800-1
Flap Transmission Gimbal Nut Adjustment wrench
727
For more information contact: TFASI
March 22 2009
AD #2578
LOCK ASSEMBLY
P/N 6ME65B02200-1
Manufacture: Pacific Support Equipment, LTD
Inboard Aileron Locks Left & Right
Used to lock either of the inboard ailerons in any of three positions for maintenance. 20 degrees up, 20 degrees down or faired.
747 ALL (except -800)
For more information contact: TFASI
2009-26-01
AD #2480
DOOR LATCH GAUGE SET
P/N 2MIT65B51544
main door latch gage set
Used to check the over center position of center bell cranks of the upper & lower door gates. (Ref 747 Chapter 52 AMM & CMM)
747
For more information contact: TFASI
Oct 26 2008
AD #2402
747 RUDDER RATIO CONTROL SYSTEM TEST
P/N TE65B83189
747 Rudder ratio control system test unit
Applicable to 747-100/-200/-300 only.
Used to detect defects in the tested rudder ratio comparator, actuator or controller. The tester allows for voltage readings to be taken with a voltmeter to check for the correct parameters.
Two available
Both Certified
For more information contact: TFASI
Sept 25 2008
AD #2386