P/N: G49005-42
APU transfer beam
Used to lower or raise auxiliary power unit (APU).Transfer APU from stand to stand
747
For more information contact: TFASI
March 23 2018
AD: #3283
Category Archives: Boeing
STRUT KEEPER
P/N: 5936854-1
Manufacture: PF Industries, Inc
MLG strut keeper
Used to keep non-pressurized MLG strut compressed for removal or installation of MLG.
MD80 series ONLY
121 Trace
For more information contact: TFASI
March 20 2015
AD #3148
747 PROTRACTOR THRUST REVERSER
P/N: MIT69B81601-1
Adapter protractor Thrust reverse levers
Used with Protractor Assembly, 4MIT65B80307 or F52485-500 for full travel angular measurements of the thrust reverser lever.
747
For more information contact: TFASI
February 2 2013
AD #3071
PLUG OXYGEN SYSTEM
P/N: MIT65B40026
Plug – Oxygen System
To plug the oxygen outlet receptacles on the flight deck for pressure & leak test of the oxygen system. For push-to-lock type receptacles.
747
129 Trace
For more information contact: TFASI
February 2 2013
AD #3069
LOCK OUT TEST SWITCH N2 ENGINE SPEED DISCRETE PCA
P/N: G21001-1
Manufacture: Spec Tool
Lock out test switch N2 engine speed discrete PCA
Used to hold the channel 1 or channel 2 switch on the N2 engine speed discrete PCA’s in the test position to simulate engines on condition during test of the equipment cooling system.
747-400 ONLY
(Ref 747-400 21 AMM)
129 Trace
For more information contact: TFASI
February 2 2013
AD #3068
TORQUE ADAPTER
P/N: 4916795-507
Used to install or remove MLG side strut nut.
DC9 series -33, -40, -50;
121 Trace
For more information contact: TFASI
August 30 2012
AD #3033
MLG Door Lock DC9 (all series- except MD80)
P/N: 3916718-1
Manufacture: SPEC TOOL
Locks Main Landing Gear Door Actuator open when aircraft on ground.
DC9 All Series (Except MD80)
121 Trace
For more information contact: TFASI
August 2 2011
AD #2913
727 / 737 NOSE MOORING
P/N: F80226-2
727 / 737 Nose Mooring
Used in conjunction with a suitable restraining cable & tiedown, furnished by customer, to facilitate mooring of the airplane. (F80226-2 flyaway kit)
Four Required.
For more information contact: TFASI
August 2 2011
AD #2908
747 Spanner Sockets
P/N: MIT65B81226
Spanner sockets elevator control feel unit
Used to torque nuts (BACN10 grip) on camshaft assembly (65B81228) of feel unit assembly elevator control (65B81226). Two sockets are required, one for each of the camshaft assembly (65B81228).
747
For more information contact: TFASI
June 20 2011
AD #2881
TORQUE WRENCH ADAPTER
P/N: ST2580-245
3 inch nominal across the flats
Used to tighten & torque the nut used to retain the body gear retract actuator rod end to the threaded boss on the gear.
747
129 Trace
For more information contact: TFASI
June 16 2011
AD #2877